Pay attention to the subnet mask of R2 in this step. In the same way, configure the Router R2 interfaces. Serial0/1 unassigned YES unset administratively down down Interface IP-Address OK? Method Status ProtocolįastEthernet0/0 192.168.5.1 YES manual up upįastEthernet0/1 unassigned YES unset administratively down down R1(config-if)#ip address 10.1.1.1 255.255.255.252Ĭheck the configuration with the show ip route command on R1. *Mar 1 00:12:57.175: %LINEPROTO-5-UPDOWN: Line protocol on Interface FastEthernet0/0, changed state to up *Mar 1 00:12:56.175: %LINK-3-UPDOWN: Interface FastEthernet0/0, changed state to up R1#conf tĮnter configuration commands, one per line.
#IA GNS3 FOR MAC SERIAL#
Open the Cisco Router R1 CLI command prompt and configure the FastEthernet 0/0 and Serial 0/0 interfaces. Pay attention to the Subnet Mask when configuring the IP address for VPCS PC3. You can perform the following commands for VPCS PC1 IP address settings. Using VPCS instead of VMware virtual machine is more efficient!Īfter opening GNS3, create a new project.Ĭreate the network topology for RIP V2 configuration as shown in the following image.Ĭonfigure VPCSs in the GNS3 workspace according to the network topology, respectively. In this article, we will use VPCS (Virtual PC Simulator) in the RIP configuration.
#IA GNS3 FOR MAC HOW TO#
How to Configure RIPv2 in GNS3īefore proceeding with the steps to enable RIPv2 on the Cisco Router, see Using VPCS. You can also watch the GNS3 RIP V1 Configuration on our YouTube channel to configure RIP V1. In this article, we will configure RIPv2 to communicate different networks on two Routers.Īfter defining the 192.168.5.0/24 network on Cisco Routers by separating it into two different networks, we will make the computers communicate on it using RIPv2. In our previous articles, we have examined What is RIP Protocol and How to Configure RIP Routing. It also prevents broadcast traffic by minimizing the use of private IP addresses.
Multicast broadcast supports VLSM and CIDR so that different subnets can communicate with each other. This protocol version sends Multicast instead of Broadcast in routing table updates.
RIP Version 2 (RIPv2) described in RFC 2453.
0 kommentar(er)
